慶旋減速機-中國減速機行業優質供應商
x
3、如用戶要改變?nèi)胼S方向，可拆卸下軸二端蓋，取出蝸桿軸，調節180。裝入即可。按裝時不可硬敲，可慢慢傳動二軸，使之嚙合。
1、 Overview of WP cast worm gear reducer:
WP worm gear reducer is developed on the basis of WD reducer. The worm gear is made of 45 # high-quality steel through heat treatment and manufacturing, and the worm gear is cast with tin bronze. It has good wear resistance, especially in terms of bearing capacity. It is mainly suitable for reducing the transmission of various mechanical equipment such as plastics, metallurgy, beverages, mines, lifting transportation, chemical construction, etc.
2、 Features of WP cast iron worm gear reducer:
1. Smooth transmission, low vibration, impact, and noise, high reduction ratio, wide versatility, and can be used in conjunction with various mechanical equipment.
2. It can achieve a larger transmission ratio through single-stage transmission, with a compact structure. Most models of reducers have good self-locking, and can save braking devices for mechanical equipment with braking requirements.
3. The meshing friction loss between the worm screw teeth and the worm gear tooth surface is relatively large, so the transmission efficiency is lower than that of gears, which is prone to heating and higher temperature.
4. Higher requirements for lubrication and cooling.
5. Good compatibility, the worm gear and worm gear are manufactured according to national standards, and standard parts are used for bearings, oil seals, etc.
6. There are two types of box body types: basic type (the box body is a vertical or horizontal structure with a bottom board) and universal type (the box body is a rectangular body with fixed screw holes on multiple sides, without a bottom board or with a separate bottom board)
7. There are two types of input shaft connection methods: basic type (single input shaft and double input shaft) and with motor flange.
8. The position direction of the output and input shafts includes the input shaft at the bottom and top; Output axis up and down; Input axis up and down.
9. Two or three reducers can be used to form a multi-stage reducer to achieve a maximum transmission ratio.
3、 Working conditions of WP cast iron worm gear reducer:
1. The worm speed of the worm gear reducer cannot exceed 1500r/min.
2. The working environment temperature is -40 ℃ -+40 ℃. When the working environment temperature is below 0 ℃, the lubricating oil must be heated to above 0 ℃ before starting. When the working environment temperature is above 40 ℃, cooling measures must be taken.
3. The input shaft of the worm gear reducer can rotate in both forward and reverse directions.
4、 Notes:
1. The worm gear shaft must not be used as an input shaft.
2. The supporting motor (i.e. power) cannot exceed the value specified on the label.
3. If the user wants to change the direction of the shaft, they can remove the two end covers of the lower shaft, take out the worm shaft, and adjust it by 180 degrees. Simply install it. Do not knock hard during installation, but slowly drive the two shafts to engage.
